Set Specific Directions
ART LOVE (31214) — wall mount
Install the one-piece ART LOVE mount using all 4 wall holes shown in the animation.
Reference 31214
YOUR SELECTED ITEM
Wall Mount for LEGO® ART LOVE (31214)
These instructions apply to this item. Follow the steps below and any item-specific notes.
Purchase this itemBefore you start
Tools needed
- Level, pencil, screwdriver and a drill and bit suitable for your wall hardware.
Parts & hardware
- 4 wall screws and suitable anchors for the wall and loaded display.
Level the empty mount and mark the wall
Hold the back of the empty mount against the wall with its supporting surface level. Allow space for the set and for lifting it on and off. Mark all 4 mounting holes.
Prepare the holes
Set the mount aside. Check the drilling location for concealed wiring and pipes. Prepare each hole according to the screw or anchor instructions. Where anchors are needed, seat them flush with the wall.
Secure the mount
Align the mount with the prepared holes. Start all 4 screws, recheck its position, and tighten them until snug. Check that the empty mount is firm against the wall.
Place the display
Support the assembled set from underneath and seat it on the mount in the orientation shown in the product photos. Check that its base is supported and that projecting details clear the wall. Release your support gradually once the set is stable.