Set Specific Directions
Boba Fett’s Starship (75312) — wall mount
Attach the ship using its carry handle and dedicated brick-ball connection. Follow the numbered reference photo for the upward-facing notch and handle position.
Reference 75312
YOUR SELECTED ITEM
Wall Mount for LEGO® Boba Fett’s Starship™ (75312)
These instructions apply to this item. Follow the steps below and any item-specific notes.
Purchase this itemBefore you start
Tools needed
- Screwdriver
- Level
- Fine-tip pencil
- Tape measure
- Stud finder and drill, if required by your wall hardware
Parts & hardware
- Dedicated notched mounting arm
- Brick ball
- Optional zip tie
- Wall screws and anchors appropriate for your wall (supplied only if ordered)
SOURCE YOUR OWN HARDWARE
Need mounting hardware?
If you did not order mounting hardware with your mount, use the specifications and links below to source the hardware you need.
Screws & Anchors (Yellow)
- Specifications
- 20.0-lb 1/4-in x 7/8-in Push-In Anchors with Screws
Lift the carry handle
Support the ship and lift the carry handle on its back. Locate the opening underneath the handle where the brick ball will sit. Panel 1 shows the raised handle; panels 2 and 3 show the installed connection.
Install the arm with its notch facing up
Choose a location with room for the complete set and clearance from nearby objects. Use screws and, where needed, anchors suitable for your wall material and the combined weight of the mount and set. Follow the hardware manufacturer’s instructions for hole size and installation. Check for concealed services before drilling. Hold the mounting part in position, check its alignment with a level, and mark the holes. The arm’s handle notch must face upward, as shown in the reference sheet. Line up the mount with the prepared holes. Start the screws, check the alignment, then tighten gradually with a screwdriver until the mount is firm against the wall. Do not overtighten or bend the printed mounting points. If the mount moves or rocks, correct the installation before adding your set.
Attach the brick ball
Screw the brick ball onto the arm, keeping the connection aligned. Tighten by hand without forcing the threads. Check that it is seated before bringing the ship to the mount.
Seat the ship and carry handle
Support the ship with both hands. Position the brick ball in the opening underneath the carry handle, then lower the handle into the notch on the arm. Check that both the brick connection and handle are engaged before releasing support.
Secure and check the display
If desired, secure the carry handle to the arm with a zip tie, as described in the reference sheet. Do not tighten enough to bend the handle. Gradually release your support only after the set is fully seated and stable. Check that the wall mount, adapter, and brick connections remain secure. If anything shifts or loosens, remove the set and correct the problem before displaying it. Support the set whenever you adjust or remove it.
