Set Specific Directions
Jango Fett’s Starship (75433) — wall mount
Follow the original installation video for the dedicated Jango Fett’s Starship 75433 mount. The UCS Firespray 75409 uses a different guide.
Reference 75433
YOUR SELECTED ITEM
Wall Mount for LEGO® Jango Fett's Starship (75433)
These instructions apply to this item. Follow the steps below and any item-specific notes.
Purchase this itemBefore you start
Tools needed
- Screwdriver
- Level
- Fine-tip pencil
- Tape measure
- Stud finder and drill, if required by your wall hardware
Parts & hardware
- Dedicated mount and attachment parts for set 75433
- Wall screws and anchors appropriate for your wall (supplied only if ordered)
SOURCE YOUR OWN HARDWARE
Need mounting hardware?
If you did not order mounting hardware with your mount, use the specifications and links below to source the hardware you need.
Screws & Anchors (Yellow)
- Specifications
- 20.0-lb 1/4-in x 7/8-in Push-In Anchors with Screws
SEE IT COME TOGETHER
Watch the installation
Watch on YouTubeFollow along with the installation ↗Opens in a new tab so you can keep these instructions handy.
Watch the set-specific demonstration
Watch the installation video above in full. Lay out your parts and identify the attachment points shown for set 75433. The original guide provides the attachment sequence in the video; follow it rather than using instructions for Boba Fett’s Starship or the UCS model.
Prepare the mounting location
Choose a location with room for the complete set and clearance from nearby objects. Use screws and, where needed, anchors suitable for your wall material and the combined weight of the mount and set. Follow the hardware manufacturer’s instructions for hole size and installation. Check for concealed services before drilling. Hold the mounting part in position, check its alignment with a level, and mark the holes.
Fit the mount and set attachment
Follow the demonstration for the mount’s orientation and set-side connection. Line up the mount with the prepared holes. Start the screws, check the alignment, then tighten gradually with a screwdriver until the mount is firm against the wall. Do not overtighten or bend the printed mounting points. If the mount moves or rocks, correct the installation before adding your set. Keep the set supported while fitting its attachment parts. Pause the video to compare each connection before continuing.
Place the set and check engagement
Attach the set following the demonstration. Keep its weight supported until every connection is fully engaged. If your parts differ from those shown, stop and contact the shop before loading the mount.
Check the finished display
Gradually release your support only after the set is fully seated and stable. Check that the wall mount, adapter, and brick connections remain secure. If anything shifts or loosens, remove the set and correct the problem before displaying it. Support the set whenever you adjust or remove it.