Set Specific Directions
Millennium Falcon (75257) — wall mount
Install the dedicated wall mount for Millennium Falcon 75257 using the marked underside attachment points. These instructions are for the wall mount, not the freestanding display stand.
Reference 75257
YOUR SELECTED ITEM
Wall Mount for LEGO® Millennium Falcon™ (75257)
These instructions apply to this item. Follow the steps below and any item-specific notes.
Purchase this itemBefore you start
Tools needed
- Screwdriver
- Level
- Fine-tip pencil
- Tape measure
- Stud finder and drill, if required by your wall hardware
Parts & hardware
- Wall mounting rail
- Set-side mounting bracket
- Wall screws and anchors appropriate for your wall (supplied only if ordered)
SOURCE YOUR OWN HARDWARE
Need mounting hardware?
If you did not order mounting hardware with your mount, use the specifications and links below to source the hardware you need.
Screws & Anchors (Yellow)
- Specifications
- 20.0-lb 1/4-in x 7/8-in Push-In Anchors with Screws
Check the mount and attachment points
Identify the straight wall rail and curved set-side bracket in the numbered photo. Carefully support the Falcon while locating the underside positions marked in red. Keep loose panels and decorative parts out of the way.
Install the wall rail
Choose a location with room for the complete set and clearance from nearby objects. Use screws and, where needed, anchors suitable for your wall material and the combined weight of the mount and set. Follow the hardware manufacturer’s instructions for hole size and installation. Check for concealed services before drilling. Hold the mounting part in position, check its alignment with a level, and mark the holes. Fit the straight rail vertically as shown in panel 1. Line up the mount with the prepared holes. Start the screws, check the alignment, then tighten gradually with a screwdriver until the mount is firm against the wall. Do not overtighten or bend the printed mounting points. If the mount moves or rocks, correct the installation before adding your set.
Fit the bracket to the Falcon
With the set supported, align the bracket’s attachment points with the underside locations marked in panel 2. Match the orientation in the inset and engage the connections fully. Do not force the bracket against unrelated plates or weak decorative sections.
Seat the set on the wall mount
Support the Falcon with both hands and bring the set-side bracket to the wall rail. Engage the parts as shown in panel 3. Keep supporting the set until the bracket is fully seated; compare the side view below before letting go.
Check the finished display
Gradually release your support only after the set is fully seated and stable. Check that the wall mount, adapter, and brick connections remain secure. If anything shifts or loosens, remove the set and correct the problem before displaying it. Support the set whenever you adjust or remove it.
