Set Specific Directions
Motorized Lighthouse (21335) — wall mount
Position and install the three support pieces. Confirm spacing with your set; the original photo’s approximately 23 cm measurement is a reference, not a drilling template.
Reference 21335
YOUR SELECTED ITEM
Wall Mount for LEGO® Motorized Lighthouse (21335)
These instructions apply to this item. Follow the steps below and any item-specific notes.
Purchase this itemBefore you start
Tools needed
- Screwdriver
- Level
- Fine-tip pencil
- Tape measure
- Stud finder and drill, if required by your wall hardware
Parts & hardware
- Three-piece Lighthouse mount
- Wall screws and anchors appropriate for your wall (supplied only if ordered)
SOURCE YOUR OWN HARDWARE
Need mounting hardware?
If you did not order mounting hardware with your mount, use the specifications and links below to source the hardware you need.
Screws & Anchors (Yellow)
- Specifications
- 20.0-lb 1/4-in x 7/8-in Push-In Anchors with Screws
Identify the three supports
Arrange the two outer brackets and center support as shown. The outer brackets face inward toward the center. Check the arrangement against your set’s underside before drilling.
Confirm the spacing
The photo shows approximately 23 cm across the indicated outer positions. Check the actual positions against your mount and Lighthouse base, including the center support. Do not use the estimated measurement alone to mark screw holes.
Mark and prepare the wall
Choose a location with room for the complete set and clearance from nearby objects. Use screws and, where needed, anchors suitable for your wall material and the combined weight of the mount and set. Follow the hardware manufacturer’s instructions for hole size and installation. Check for concealed services before drilling. Hold the mounting part in position, check its alignment with a level, and mark the holes. Hold each support in its checked position. Keep the support surfaces level and mark all mounting holes.
Secure all three supports
Line up the mount with the prepared holes. Start the screws, check the alignment, then tighten gradually with a screwdriver until the mount is firm against the wall. Do not overtighten or bend the printed mounting points. If the mount moves or rocks, correct the installation before adding your set. Check the spacing and level across all three parts before adding the Lighthouse.
Place the Lighthouse
Lift the set by its supported base, with help if needed, and lower it carefully onto the three supports. Check that the base sits on the intended areas and that wiring and moving parts are not trapped.
Check the finished display
Gradually release your support only after the set is fully seated and stable. Check that the wall mount, adapter, and brick connections remain secure. If anything shifts or loosens, remove the set and correct the problem before displaying it. Support the set whenever you adjust or remove it.