Set Specific Directions
NASA Hubble Space Telescope (10283) — Mini Arm wall mount
Mount the Mini Arm to the wall, then fit the custom top level and hand-tighten its locking collar.
Reference 10283
YOUR SELECTED ITEM
Wall Mount for LEGO® NASA Hubble Space Telescope (10283)
These instructions apply to this item. Follow the steps below and any item-specific notes.
Purchase this itemBefore you start
Tools needed
- Level, pencil, screwdriver, tape measure, and a drill and bit suitable for your wall hardware.
Parts & hardware
- Mini Arm, set-specific custom top and locking collar; 2 wall screws and suitable anchors.
Mark the empty arm position
Hold the empty arm against the wall, check its alignment and mark both mounting holes. Keep the custom top aside while securing the arm.
Prepare the wall
Check for concealed wiring and pipes. Prepare each marked hole and fit suitable wall anchors according to the hardware instructions. Seat the yellow anchors flush where used.
Secure the arm
Start every wall screw, recheck alignment, then tighten gradually until snug without bending the printed parts. Check the empty mount for movement before loading it.
Fit the optional cover
If supplied, slide the NASA screw cover over the arm as shown without forcing it.
Fit the custom top
Fit the top to the joint and hold its supporting surface level. Thread the locking collar on by hand and tighten until the top holds securely. Keep the threads aligned; do not overtighten.
Place the set
Support the set from underneath and lower it onto its intended support areas. Check that it is fully seated and stable before releasing your support. Remove the set before adjusting or tightening the mount.