Set Specific Directions
Wall Mount for LEGO® The X-Files (21369)
Use two Large brackets on a flat wall or two Wedge brackets in an inside corner. Match the tray hole pattern to the selected layout.
Reference 21369
These instructions apply to this item. Follow the steps below and any item-specific notes.
Before you start
Tools needed
- Level, pencil, screwdriver, drill and bit matched to the fasteners.
Parts & hardware
- Large · flat wall — 2 brackets, 4 tray screws with washers, 8 wall screws
- Wedge · inside corner — 2 brackets, 8 tray screws with washers, 4 wall screws
Align the tray and brackets
Use two Large brackets on a flat wall or two Wedge brackets in an inside corner. Match the tray hole pattern to the selected layout. On a stable surface, line up the recessed tray holes with the bracket inserts shown in the animation. Face the flat mounting surfaces toward the wall.
Fasten the tray before marking the wall
Place a washer in each selected recess. Start the supplied low-profile M3 screws through the tray into the threaded bracket inserts by hand. Tighten evenly until snug. Check that the tray and brackets sit firmly together.
Level the tray and mark the wall for your layout
For the flat-wall layout, hold the assembled tray level and mark all eight holes through the Large brackets. For an inside corner, hold the empty tray level with one Wedge against each wall. Mark both holes on each wall. Check for concealed wiring or pipes before drilling.
Prepare the wall and secure the mount
Set the mount aside. Use fasteners rated for your wall and the loaded display. For drywall anchors, drill to the specified size and fit the anchors flush. For a stud, follow the screw manufacturer’s pilot-hole instructions. Align the empty mount and start all wall screws. Check the level, tighten until snug and check for movement.
Seat the display
Lower the display onto the installed tray with support beneath its base. Check the model’s clearance from each adjacent wall. Release your support gradually. If the model rocks or the mount shifts, lift the set off before adjusting it.