Set Specific Directions
Wall Mount for LEGO® Saturn V Rocket (92176)
Arrange the support segments using the labeled reference photo. Check their positions against your rocket before marking or drilling the wall.
Reference 92176
These instructions apply to this item. Follow the steps below and any item-specific notes.
Purchase this itemBefore you start
Tools needed
- Screwdriver
- Level
- Fine-tip pencil
- Tape measure
- Stud finder and drill, if required by your wall hardware
Parts & hardware
- Saturn V segmented wall-mount kit
- Wall screws and anchors appropriate for your wall (supplied only if ordered)
SOURCE YOUR OWN HARDWARE
Need mounting hardware?
If you did not order mounting hardware with your mount, use the specifications and links below to source the hardware you need.
Screws & Anchors (White/Blue)
- Specifications
- 25.0-lb 3/16-in x 1-1/4-in Push-In Anchors with Screws
Identify the support segments
Compare your parts with the labeled positions: TOP_TOP, TOP_BOTTOM, MIDDLE_TOP, MIDDLE_BOT, BOTTOM-TOP, and BOTTOM_BOT. These show the support arrangement along the rocket. The photo is not a full-size drilling template.
Plan the spacing using your rocket
With the rocket safely supported, work out the positions for its sections and your mount parts. Decide whether to display the sections together or separated, as in this example. Check that every section will be supported before transferring the positions to the wall.
Mark and prepare the wall
Choose a location with room for the complete set and clearance from nearby objects. Use screws and, where needed, anchors suitable for your wall material and the combined weight of the mount and set. Follow the hardware manufacturer’s instructions for hole size and installation. Check for concealed services before drilling. Hold the mounting part in position, check its alignment with a level, and mark the holes. Use your checked segment positions to mark the holes. Recheck overall alignment and clearance between sections.
Install the mount segments
Line up the mount with the prepared holes. Start the screws, check the alignment, then tighten gradually with a screwdriver until the mount is firm against the wall. Do not overtighten or bend the printed mounting points. If the mount moves or rocks, correct the installation before adding your set. Install each segment in its matching position. Check the complete arrangement before loading it.
Place the rocket sections
Support each section while placing it in its matching mount positions. Make sure each sits correctly on its supports. If spacing is wrong or a connection is incomplete, remove the section before adjusting the mounts.
Check the finished display
Gradually release your support only after the set is fully seated and stable. Check that the wall mount, adapter, and brick connections remain secure. If anything shifts or loosens, remove the set and correct the problem before displaying it. Support the set whenever you adjust or remove it.