Set Specific Directions
Simple Wall Mount for LEGO® Retro Record Player (40699)
Install the Slim or Wedge mount selected in your order, each with an integrated 2 × 4 brick attachment. The animation illustrates the Wedge version. The written steps below cover both styles.
Reference 40699
These instructions apply to this item. Follow the steps below and any item-specific notes.
Purchase this itemBefore you start
Tools needed
- Screwdriver with a bit that fits your wall screws
- Level
- Fine-tip pen or pencil
- Stud finder, if needed
- Drill and drill bit, if needed for your screws or anchors
- Tape measure, if needed
Parts & hardware
- 1 Slim or Wedge bracket with integrated 2 × 4 attachment, matching your order
- Wall screws and suitable anchors for every mounting hole in the supplied bracket (included only if ordered)
Check the mounting position
Check that the supplied bracket matches the Slim or Wedge style selected in your order. Both styles have an integrated 2 × 4 attachment; no separate tray or ball joint is required. Identify a strong compatible connection beneath the set. The animation shows the Wedge version; use your supplied Slim bracket in the same wall-facing orientation when following these written steps.
Mark the wall
Hold the empty Slim or Wedge bracket with its wall-mounting face flat against the wall and its integrated 2 × 4 top supporting the set from below. Check alignment and mark every mounting hole in the supplied bracket. Allow space for the complete set.
Prepare the wall
Check for concealed wiring and pipes. Prepare each marked hole and fit suitable wall anchors according to the hardware instructions. Seat each anchor flush where used.
Secure the Slim or Wedge mount
Start every wall screw, recheck alignment, then tighten gradually until snug without bending the printed parts. Check the empty mount for movement before loading it.
Attach the set
Support the set from underneath and lower it onto the intended attachment points. Check that all connections are fully engaged and stable before releasing your support. Remove the set before moving or retightening the mount.