Set Specific Directions
Wall Mount for LEGO® Beauty and the Beast Castle (43263)
Position the left and right castle supports using the actual set underside. The animation shows illustrative spacing.
Reference 43263
These instructions apply to this item. Follow the steps below and any item-specific notes.
Purchase this itemBefore you start
Tools needed
- Screwdriver with a bit that fits your wall screws
- Level
- Tape measure
- Fine-tip pen or pencil
- Stud finder, if needed
- Drill and drill bit, if needed for your screws or anchors
Parts & hardware
- Left and right set-specific brackets
- 4 wall screws and suitable anchors (if ordered)
Position the left and right supports
Match each bracket to its intended contact points beneath the castle. Determine the spacing from your actual model; the animation is not a drilling template.
Mark the wall
Hold both empty brackets at the measured spacing, level their support surfaces and mark all four mounting holes.
Prepare the wall
Check for concealed wiring and pipes. Prepare each marked hole and fit suitable anchors according to the supplied hardware instructions and your wall material.
Secure both brackets
Start all wall screws, check alignment, and tighten gradually until snug without bending the printed parts. Check the empty mount for movement before loading.
Place the castle
Support the model with both hands and place it on its intended supports. Check every connection is fully engaged and the model is stable before releasing your support. Remove the model before moving or retightening the wall mount.