Set Specific Directions
Simple Wall Mount for LEGO® Disney Pixar Luxo Jr. (21357)
Install the Wedge mount with its integrated 2 × 4 brick attachment. Choose the lamp-only animation for one mount or lamp-and-ball for two mounts.
Reference 21357
These instructions apply to this item. Follow the steps below and any item-specific notes.
Purchase this itemBefore you start
Tools needed
- Screwdriver with a bit that fits your wall screws
- Level
- Fine-tip pen or pencil
- Stud finder, if needed
- Drill and drill bit, if needed for your screws or anchors
- Tape measure, if needed
Parts & hardware
- Lamp only: 1 Wedge with 2 × 4 attachment, 2 wall screws and suitable anchors.
- Lamp and ball: 2 Wedges with 2 × 4 attachments, 4 wall screws and suitable anchors.
Check the mounting position
Identify a strong compatible connection beneath the set for the integrated 2 × 4 top. For lamp and ball, use both supplied mounts and measure their positions against the actual models. The gap shown is illustrative.
Mark the wall
Hold each empty mount against the wall in the orientation shown, check alignment, and mark its two mounting holes. Allow space for the complete set.
Prepare the wall
Check for concealed wiring and pipes. Prepare each marked hole and fit suitable wall anchors according to the hardware instructions. Seat each anchor flush where used.
Secure the Wedge mount
Start every wall screw, recheck alignment, then tighten gradually until snug without bending the printed parts. Check the empty mount for movement before loading it.
Attach the set
Support the set from underneath and lower it onto the intended attachment points. Check that all connections are fully engaged and stable before releasing your support. Remove the set before moving or retightening the mount.