Set Specific Directions
Wall Mount for LEGO® The Lord of the Rings: Sauron's Helmet (11373)
Mount Sauron’s Helmet (11373) on the wall using its assembled display base. The tray is marked for Sauron’s Helmet and Editions helmets. Use the animation to install the empty tray, then follow the final step to seat the base while keeping the tall spikes clear of the wall.
Reference 11373
These instructions apply to this item. Follow the steps below and any item-specific notes.
Purchase this itemBefore you start
Tools needed
- Pencil and level
- Screwdriver to fit your screws
- Stud finder if mounting into a stud
- Drill and bit sized for your wall hardware, if required
Parts & hardware
- 1 Sauron / Editions helmet wall mount per helmet
- 2 wall screws suitable for the wall and the loaded mount
- Matching anchors where required for your wall (hardware included only if ordered)
Orient the empty mount
Hold the flat back of the mount against the wall with the two screw holes one above the other. The lettering on the tray faces up, and the two short stops at the front point into the room. Allow enough space above the tallest spike to lift the helmet and its base clear of the tray.
Mark both screw holes
Choose a stud where practical, or use anchors rated for your wall and the combined weight of the helmet and mount. Check for hidden wiring and pipes. Hold the tray level and mark the center of each hole through the backplate. Set the mount aside.
Prepare the wall
For drywall anchors, drill at the two pencil marks using the bit size and depth specified for your anchors. Fit each anchor as directed. The animation shows push-in anchors seated flush with the wall. For a stud installation, drill pilot holes as specified for your screws.
Fasten the tray
Align the backplate with the two prepared holes. Start both screws, recheck that the tray is level, then tighten each screw until the backplate sits snugly against the wall. Stop before the printed part bends. Check the empty tray for rocking or movement before loading it.
Seat Sauron’s display base
Lift the assembled helmet with both hands under its display base. Keep the spikes clear of the wall as you lower the base onto the tray. Seat the base flat between the side rails and behind the two front stops. Check that no edge rests on top of a stop. Ease your hands away only when the base sits steadily. If it rocks, lift it out and check the seating. To remove the helmet, support the base and lift it clear of the stops before pulling it forward.