Set Specific Directions
Wall Mount for Captain America's Shield (76262)
Assemble and install the tray, then position the shield and its stand. The final reference photo shows optional zip-tie locations for securing the shield to the stand and the stand to the tray.
Reference 76262
These instructions apply to this item. Follow the steps below and any item-specific notes.
Purchase this itemBefore you start
Tools needed
- Screwdriver
- Level
- Fine-tip pencil
- Tape measure
- Stud finder and drill, if required by your wall hardware
Parts & hardware
- Tray
- Matching brackets
- Supplied assembly screws and washers
- Optional zip ties
- Wall screws and anchors appropriate for your wall (supplied only if ordered)
SOURCE YOUR OWN HARDWARE
Need mounting hardware?
If you did not order mounting hardware with your mount, use the specifications and links below to source the hardware you need.
Screws & Anchors (Yellow)
- Specifications
- 20.0-lb 1/4-in x 7/8-in Push-In Anchors with Screws
Check the tray and brackets
Lay out the tray, supplied brackets, assembly screws, and washers.
Attach the brackets to the tray
Align the tray’s attachment points with the brackets. Fit the supplied assembly screws and washers, starting each screw before tightening the others. Tighten gradually until secure without bending or crushing the printed parts.
Mark the wall holes
Choose a location with room for the complete set and clearance from nearby objects. Use screws and, where needed, anchors suitable for your wall material and the combined weight of the mount and set. Follow the hardware manufacturer’s instructions for hole size and installation. Check for concealed services before drilling. Hold the mounting part in position, check its alignment with a level, and mark the holes. Hold the assembled tray against the wall. Check that its surface is level before marking every bracket hole.
Install the assembled mount
Line up the mount with the prepared holes. Start the screws, check the alignment, then tighten gradually with a screwdriver until the mount is firm against the wall. Do not overtighten or bend the printed mounting points. If the mount moves or rocks, correct the installation before adding your set. Recheck the tray with a level and make sure all brackets sit firmly against the wall.
Position the shield and stand
With help if needed, lift the shield and its stand onto the tray. Center the stand on its intended support area. Keep supporting the shield until the display is stable, with no part of the stand overhanging an unsupported edge.
Add optional zip ties
If using zip ties, follow the arrowed locations to secure the shield to its stand and the stand to the tray. Keep ties clear of decorative pieces and tighten only enough to retain the parts without distorting them. Zip ties do not correct an unstable stand or loose wall hardware.
Check the finished display
Gradually release your support only after the set is fully seated and stable. Check that the wall mount, adapter, and brick connections remain secure. If anything shifts or loosens, remove the set and correct the problem before displaying it. Support the set whenever you adjust or remove it.