Set Specific Directions
Vertical Wall Mount for LEGO® Star Trek: U.S.S. Enterprise NCC-1701-D™ (10356)
Install the set-specific vertical Enterprise mount with its four wall fixings, then seat the model on the supplied supports.
Reference 10356
These instructions apply to this item. Follow the steps below and any item-specific notes.
Purchase this itemBefore you start
Tools needed
- Screwdriver with a bit that fits your wall screws
- Level
- Fine-tip pen or pencil
- Stud finder, if needed
- Drill and drill bit, if needed for your screws or anchors
- Tape measure, if needed
Parts & hardware
- One-piece vertical Enterprise mount
- 4 wall screws and suitable anchors (if ordered)
Mark the mount position
Choose the guide for the style selected in your order. These steps cover the Vertical mount. For the Horizontal (bow left / bow right) option, follow https://install.bp3dprintshop.com/products/766d6cc8-d0f2-4bd3-8397-9fad8f8531f4 instead. Hold the empty mount against the wall in the orientation shown, check it is level and mark all four mounting holes. Allow clearance for the complete Enterprise.
Prepare the wall
Check for concealed wiring and pipes. Prepare each marked hole and fit suitable anchors according to the supplied hardware instructions and your wall material.
Secure the mount
Start all wall screws, check alignment, and tighten gradually until snug without bending the printed parts. Check the empty mount for movement before loading.
Place the Enterprise
Support the model with both hands and place it on its intended supports. Check every connection is fully engaged and the model is stable before releasing your support. Remove the model before moving or retightening the wall mount.