Set Specific Directions
Adjustable Wall Mount for LEGO® Shuttle Carrier Aircraft (10360)
Install the arm-style mount using the set-specific video for the adapter and zip ties. The vertical cleat mount has a separate guide.
Reference 10360
These instructions apply to this item. Follow the steps below and any item-specific notes.
Purchase this itemBefore you start
Tools needed
- Screwdriver
- Level
- Fine-tip pencil
- Tape measure
- Stud finder and drill, if required by your wall hardware
Parts & hardware
- Mounting arm
- Custom adapter ball
- Included zip ties
- Optional screw cover
- Wall screws and anchors appropriate for your wall (supplied only if ordered)
SOURCE YOUR OWN HARDWARE
Need mounting hardware?
If you did not order mounting hardware with your mount, use the specifications and links below to source the hardware you need.
Screws & Anchors (Yellow)
- Specifications
- 20.0-lb 1/4-in x 7/8-in Push-In Anchors with Screws
SEE IT COME TOGETHER
Watch the installation
Watch on YouTubeFollow along with the installation ↗Opens in a new tab so you can keep these instructions handy.
Review the adapter demonstration
Choose the guide for the style selected in your order. These steps cover the Adjustable mount. For the Vertical option, follow https://install.bp3dprintshop.com/products/573b26d3-8924-4a8d-be82-f74ab74cb96f instead. Watch the installation video above to identify the adapter position and zip-tie routing for set 10360. The original guide also includes this general arm-mount walkthrough: https://www.youtube.com/watch?v=8em6dy947v8
Prepare and secure the arm
Choose a location with room for the complete set and clearance from nearby objects. Use screws and, where needed, anchors suitable for your wall material and the combined weight of the mount and set. Follow the hardware manufacturer’s instructions for hole size and installation. Check for concealed services before drilling. Hold the mounting part in position, check its alignment with a level, and mark the holes. Line up the mount with the prepared holes. Start the screws, check the alignment, then tighten gradually with a screwdriver until the mount is firm against the wall. Do not overtighten or bend the printed mounting points. If the mount moves or rocks, correct the installation before adding your set.
Fit the optional screw cover
If supplied, slide the screw cover over the arm and guide it over the wall screws. It is held in place by friction and gravity. Support the arm and avoid heavy downward pressure. If the cover catches, stop and check its orientation instead of forcing it.
Attach the adapter to the aircraft
Keep the aircraft supported while fitting the custom adapter in the position shown in the set-specific video. Route and tighten the included ties as demonstrated. Check that the adapter stays seated and the ties do not distort the set’s structure.
Connect the set to the arm
Support the aircraft’s weight while attaching its adapter ball to the installed arm. Keep the connection aligned and tighten by hand. Do not let the aircraft hang from a partly engaged connection.
Adjust the angle and check stability
Support the set’s full weight while making small adjustments. Start with a level or modest angle and check that the set clears the wall. Hand-tighten the joint only enough to hold the chosen position; do not force or overtighten it. Steep or overly aggressive angles can move the set’s center of mass away from its support and strain the joint and brick connections. The set could detach or fall. The joint’s range of movement does not mean every angle is suitable. If the set slips, tips, or pulls apart, support it immediately, reduce the angle, or remove it and check the attachment. Gradually release your support only after the set is fully seated and stable. Check that the wall mount, adapter, and brick connections remain secure. If anything shifts or loosens, remove the set and correct the problem before displaying it. Support the set whenever you adjust or remove it.